At 8am we went and finished the pink batts insulation then at 9am the insectors came in to check over the hoouse til bout 9.30am then after that me and tk started on the last window sciber.
til 10am we had first break til bout 10.30am then went back too workshop and me and tk went back too scriber.
til 12pm then had lunch break til 1pm and went to the eshed and done our assessments til 3pm then had last break til 3.20pm and me and tk done the last window flashing and put tape on top.
extra notes about gib- boarding:
manufacturing of gib plasterboards:
Paper tape is 3 x stronger then fibre tape.
Gib board must be stored flat on the round.
substrate must be straight and dry
Joints around opening- not acceptable because could cause cracking.
Control joints are to avoid cracking
control joints are gaps between the two sheets
Back Blocking
Use the whole wall
150mm centres around to 7.5mm
100mm centres around 7.5-100mm
Tiled areas must be mechanically fastened. Not adhesive fixed.
STC- sound transmission class
68 is max for plaster board sound control.
 |
| the last window scriber done and installed.. |
 |
| the flashing on the window.. |
 |
| tk putting the tape on the flashing |
No comments:
Post a Comment