tools we used was hammer for tacking the studs and bottom plate, measuring tape for measuring, combination square for squaring off marking, radial arm saw for cutting bottom plate and studs..
today we started setting the wall framming bit we put bottom plates on then the studs for set out of the windows..
we cut the factory edges off the studs after measuring it and tacking it before cutting it with the radial arm saw.
 |
| measuring and calculations |
 |
| bottom plate measuring |
 |
| studs and bottom plate |
 |
| looking at the plans for next piece |
 |
| picture of rangi using the radial arm saw |
 |
| set out for walls |
 |
| set out and cutting timber for the walls |
 |
| tacking them together |
No comments:
Post a Comment